|
A complete washout assembly that replaces the stock plastic unit. CNC machined alloy control arms have twin sealed ballraces and high stainless steel M3 control hardware. Alloy washout base features precision bored brass sleeve for a smooth and long lasting slide action.
Supplied complete with re... |
|
|
Alloy washout base features precision reamed brass sleeve for a smooth and long lasting slide action. A direct replacement for the standard plastic part supplied complete with control arm mounting screws and shims.
Suitable for use with standard TT plastic washout arms.
Available in Blue and S... |
|
|
These control levers are very substantial and perfect for the high control loads encountered during demanding 3D style flying
Machined from solid and fitted with extra wide (5mm each) twin bearings for zero side movement and high durability. Control balls are stainless steel with M3 fixing threa... |
|
|
This superb quality swashplate uses a high quality radial bearing and an aviation grade PTFE lined chrome steel centre swivel ball. The main bearing features special pre-load adjusters to eliminate any play and allow future re-tensioning.
Stainless steel control balls with M3 fittings, a must for... |
|
|
This upper mast bearing block provides substantial additional bracing helping to prevent upper frame flexing and the associated vibration.
Fitted with a high load Japanese specification bearing to ensure smooth running and long life.
Available in Blue or Silver finish |
|
|
A matching lower bearing block to compliment the upper unit.
Designed to give maximum mounting face area to resist frame flex and twist whilst being as light as possible.
A high load Japanese specification bearing is used for smooth running and long life.
Available in Blue or Silver finish
... |
|
|
This hub represents a total redesign over the original TT unit and features a very high quality German one-way clutch bearing that incorporates twin needle roller support bearings in place of the plain bushes used by TT.
A new 18mm hardened steel core allows the use of the larger clutch bearing g... |
|
|
Superb high efficiency lightweight alloy cooling fan for the Raptor 60/90, 25% lighter than our previous design and now only 6 g heavier than the original plastic unit.
Incorporates an accurate twin collet fitting system to suit OS and YS 61 - 91 engines. Up to 35% more efficient than the s... |
|
|
Replacement brass taper collet set for use with cooling fan R6D-07.
Supplied as a set including upper & lower collets for both OS and YS engines |
|
|
Removal tool suitable for use with our twin collet cooling fan.
Provides safe and easy removal of the fan without any risk of damage. Simply bolt on in place of the clutch, tighten the centre screw and the fan pushes away from the taper collets.
Under no circumstances should a conventional &qu... |
|
|
